PRE-ORDER Fullmetal Cutie Printed Cosplay Skirt

Current Stock:
Petticoat Add-On
Size (required)
PRE-ORDER -- I will be making some tweaks to this design: the red will be a bit deeper; I will be changing some of the graphic placements; I'll also be adding lace or scalloping details to some of the elements to make the skirt less plain. If you want the skirt as is, feel free to order this pre-order version and just put that you want the original version in the notes. If you don't indicate that you want it as is, I'll be making the new version for you.
This A-Line, high-waisted skirt is wonderfully stretchy to accommodate fluctuating sizes. The fabric is 90% polyester and 10% spandex with a heat sublimated printed design and white stitching along the edges. Design placement might differ slightly from garment-to-garment since they are all individually made, but they will not be shipped if they are significantly different, so no worries  =3
This skirt is a little longer than my usual printed skater dresses, so you might want to invest in a longer petticoat. You can also just pull the petticoats I offer farther down on your hips if you don't want to invest in a knee-length petticoat  ^_^
See the sizing chart below and use your measurements to find your best size. Your waist measurement is the only measurement you'll need for this design. Your hip measurement is not important for printed skirts since the skirts are not tight at the hips.
BUST 31-32 33-34 35-36 37-39 40-41 42-45 46-49
WAIST 23-24 25-26 27-28 229-31 32-34 35-38 35-38
HIPS 33-34 35-36 37-38 39-41 42-45 46-48 49-52
US SIZE 0-2 4-6 8-10 12-14 16-18 20-22 24-26

For printed items, I only design the textiles and do not sew all parts in-house like my other designs.  Please check the banner at the top of the website for current construction times as I'm a new mom and am adjusting to working while being a full-time mama. You can expect construction times to range from 2-8 weeks (although 4 weeks is the average for printed items). Since these are printed, a small ink spot may sneak its way onto parts of the fabric; this is to be expected since these are printed directly onto the fabric. Keep in mind that I won't ship any designs if I see the small imperfections that are larger than 1/3 of an inch. Also keep in mind that this fabric is stretched and sewn inside out; the sides of the dress may not always match up perfectly and some deviation is to be expected in terms of the print. Like the imperfections, I will not send your order out if it deviates more than an acceptable amount.
Handwash with cold water, please. Lay flat or hang in indirect sunlight for best drying results. An iron on the synthetic setting (with or without steam) works great. If you don't trust your iron or haven't cleaned it in awhile, I always suggest ironing garments inside out so you don't stain them with sediment that's built up in the iron.

Related products

Customers also Viewed